Table of Contents
Advertisement
Remote Control
1.
Power ON / OFF
Turns power on and off.
2. Pic Mute OPEN / CLOSE
Shows and hides the projected image.
There are two PIC Mute settings:
•
Laser. When off, the laser is switched off and no image is projected
•
DMD Blanking. When off, the laser remains on and a black image is projected
3. OSD ON / OFF
Enable and disable screen timeout messages and control whether to show the OSD
during projection.
4. MENU
Access the OSD. If the OSD is open, press this button to go back to the previous menu.
5. Navigation (arrows and OK)
Navigate through the menus with the arrows, confirm your choice with OK.
In lens adjustment modes, the arrows are used to move, zoom or focus the lens.
See 11 below. In lens adjustment modes, or when the OSD is not showing,
the OK button switches between modes: Shift Adjustment and Zoom / Focus Adjustment.
6. EXIT
Go up one level in the OSD. When the top level is reached, press to close the OSD.
7.
FREEZE
Freeze the current frame.
8. DEFAULT
When editing a parameter, press this button to restore the default value.
9. INFO
Access information about the projector.
10. RE-SYNC
Re-synchronise with the current input signal.
Installation & Quick Start Guide
REMOTE CONTROL
1
2
3
4
5
6
7
Remote Control
Digital Projection Ltd. M-Vision WUXGA Series
Notes
The "PIC mute setting" is
defined in the setup menu.
See "Setup menu" on page
77
8
9
10
Rev A January 2024
page 21
Advertisement
Table of Contents
