Table of Contents
Advertisement
Digital Projection Ltd. M-Vision WUXGA Series
•
Trigger
Choose from Off, Screen, 5:4, 4:3, 16:10, 16:9, 1.88, 2.35, TheaterScope, Source,
Unscaled or RS232 to determine what will cause each trigger output to activate.
•
Infrared Remote
Set to Off if you wish to disable the remote control.
•
IR Code
The projector and the remote control need a matching IR code: a two-digit number
between 00 and 99 . The default IR code is 00 . This is also a master code, which,
if assigned to a remote, will work regardless of the value assigned to the projector.
•
To assign an IR code for the projector: Select IR code. Use the UP and DOWN arrow buttons to change the values.
•
To assign an IR code for the remote, press and hold the ADDR button on the remote until the On indicator starts flashing.
Release the ADDR button and while the indicator is still flashing, enter a two digit address using the numeric input buttons.
The indicator will flash three times quickly to confirm the change.
•
IR Code Reset
Use this command to unassign an IR code from the projector. This will revert the IR Code value to 00.
To unassign an IR code from the remote control, press and hold ALT and ADDR simultaneously until the On indicator flashes
to confirm the change.
•
OSD Settings
Access this submenu to adjust the appearance and position of the on-screen display.
•
Memory
Access this submenu to save up to four presets containing custom combinations of image settings, or to recall a saved preset.
•
EDID Mode
Access this submenu to set the frame rate and display resolution for each input type.
•
Output Frame Rate
Choose from Auto, 48Hz, 50Hz and 60Hz. Select Auto to use the same frame rate as the input signal. When switching
between inputs on auto output frame rate, the projector measures the input frame rate before setting the output frame rate.
When you know that all input frame rates are the same value, you can set an output frame rate to reduce the time it takes to
switch between inputs.
Rev A January 2024
page 78
USING THE PROJECTOR
Setup
Trigger
Infrared Remote
IR Code
IR Code Reset
OSD Settings
Memory
EDID Mode
Output Frame Rate
Image Latency
CW Effect
Scroll
The Projector Controller
software is available for
Off
Off
download from the Digital
0
Projection website, free of
charge.
Auto
A wired remote control will
Normal
Performance
also be disabled if Infrared
Remote is set to Off.
Enter
Back
Notes
Operating Guide
Advertisement
Table of Contents
