Table of Contents
Advertisement
Digital Projection Ltd. M-Vision WUXGA Series
Operating the projector
Switching the projector on:
1.
Connect the power cable between the mains supply and the projector. (See Connecting the power supply above.) Switch
the breaker switch next to the power connector to on.
The POWER indicator turns red to signal that the projector is on and in STANDBY mode.
2. Press one of the following buttons:
•
On the remote control, the ON button
•
On the projector control panel, the POWER button.
The POWER indicator begins flashing green as the projector powers up. When the flashing stops, the POWER and LIGHT indicator
both lights solid green and the Digital Projection logo appears on the screen. The projector is switched on and projecting.
Switching the projector off
1.
Press OFF on the remote control or POWER on the control panel, then press again to confirm your choice.
The POWER indicator on the control panel will start flashing blue, the projected image will turn off and the cooling fans will
run for a short time until the POWER indicator goes steady red to indicate that the projector has entered STANDBY mode.
2. If you need to switch the projector off completely, switch the breaker switch next to the power connector to off and then
disconnect the power cable from the projector.
Selecting an input signal
1.
Connect one or more image sources to the projector.
2. Select the input you want to display:
•
Press one of the input buttons on the remote control.
•
Alternatively, open the On-screen display (OSD) by pressing MENU. Highlight Input from the main menu,
press ENTER/OK and then select an input signal using the UP and DOWN arrow buttons. Press ENTER/OK to confirm
your choice.
Selecting a test pattern
The following test patterns are available:Off, White, Black, Red, Green, Blue, Checkerboard, Crosshatch, Color Bar, Aspect Ratio
To display a test pattern:
•
Press TEST on the remote control.
Change the test pattern using the LEFT and RIGHT arrow buttons.
•
Alternatively, open the OSD by pressing MENU. Highlight Test Patterns from the main menu, then select a test pattern using
the LEFT and RIGHT arrow buttons.
After the final test pattern, the projector exits test pattern mode and returns to the main image. To view test patterns again, you
need to press TEST again. If you wish to exit the test patterns before you reach the final one, press TEST or EXIT at any time.
Rev A January 2024
page 32
OPERATING THE PROJECTOR
Notes
See "Connecting The Power
Supply" on page
31.
The self-test is running when
all the LEDs on the control
panel are lit.
Use only the power cable
provided.
Ensure that the power
outlet includes a ground
connection as this
equipment MUST be
earthed.
Handle the power cable
carefully and avoid sharp
bends. Do not use a
damaged power cable.
See "Using the menus" on
page 44 for full details of
how to use the controls and
the menu system.
Installation & Quick Start Guide
Advertisement
Table of Contents
