Table of Contents
Advertisement
Control panel
1.
TEMP INDICATOR
Off = no problem
Flashing red = temperature error
2. LIGHT INDICATOR
Off = light is switched off
Flashing red (cycles of single flashes) = failure to light up during power up
Flashing red (cycles of double flashes) = unexpected light off while running
On, green = light is switched on
On, orange = light is switched on but run on forced eco mode when high
temperature
Flashing green (cycles of single flashes) = light source is temporary off by
PIC-MUTE CLOSE.
3. STATUS INDICATOR
Off = no problem
Flashing red (continuously) = cover error
Flashing red (cycles of single flashes) = TEC/color Sensor error
Flashing red (cycles of four flashes) = fan error
On, red = system error
On, orange = firmware upgrade mode
Flashing orange (cycles of double flashes) = request to re-execute the lens calibration (Center Lens) process
Flashing green (cycles of double flashes) = lens calibration (Center Lens) is processing
4. POWER
Switches the projector on and off (STANDBY).
Indicator:
Off.
The projector is switched off
Flashing green.
The projector is warming up
Flashing orange.
The projector is cooling down
On, red.
Standby mode: power saving without network control capability.
On, orange
Standby mode: with network control capability
On, green
The projector is switched on.
5. SYNC
Re-synchronises with the current input signal.
Installation & Quick Start Guide
CONTROL PANEL
1
2
4
5
6
7
8
9
15
Control panel
Digital Projection Ltd. M-Vision WUXGA Series
3
10
11
12
13
14
16
Notes
Rev A January 2024
page 19
Advertisement
Table of Contents
