EDID on the DisplayPort, HDMI, and HDbaseT inputs
If you are using a computer graphics card or another source that obeys the EDID protocol, the source will automatically configure itself
to suit the capability of the projector.
Otherwise refer to the documentation supplied with the source to manually set the resolution to the DMD™ resolution of the projector
or the nearest suitable setting. Switch off the source, connect to the projector, then switch the source back on again.
Using DisplayPort/ HDMI/ HDBaseT switchers with the projector
When using a DisplayPort/HDMI/HDBaseT source switcher with the projector, it is important to set the switcher so that it passes the
projector EDID through to the source devices.
If this is not done, the projector may not be able to lock to the source or display the source correctly as its video output timings may
not be compatible with those of the projector. Sometimes this is called transparent, pass-through or clone mode. See your switcher's
manual for information on how to set this mode.
1.
Sources
2. Switcher
3. Projector
Connection Guide
1
2
The EDIDs in the switcher should be the same as the one in the projector.
SIGNAL INPUTS
3
Digital Projection Ltd. M-Vision WUXGA Series
Notes
Rev A January 2024
page 37