Table of Contents
Advertisement
Adjusting the lens
The lens can be adjusted using the Lens menu, or using the lens buttons on the remote control.
Lens menu
The Lens menu provides access to the Lens Control setting and the Lens Center command.
Lens Control allows Zoom, Focus and Shift adjustments using the arrow buttons. The setting operates in Zoom/Focus Adjustment
and Shift Adjustment mode.
Press ENTER/SELECT to switch between the two modes.
Remote control
Use the remote control to adjust zoom, focus and shift directly, without opening a menu:
•
OK enters lens control, then switches between Zoom/Focus Adjustment and Shift Adjustment.
•
EXIT exits lens control and opens the Lens menu.
•
MENU exits lens control and returns to the main image.
•
The arrow buttons adjust zoom, focus and shift as indicated on the screen.Selecting a test pattern
Adjusting the image
Orientation
This can be set from the Setup menu.
Highlight Orientation and choose from Front Tabletop, Front Ceiling, Rear Tabletop, Rear Ceiling and Auto-front.
Geometry
Settings such as Keystone, Pincushion / Barrel can be set from the Geometry menu.
Picture
Settings such as Gamma, Brightness, Contrast, Saturation, Hue and Sharpness can be set from the Image menu
Installation & Quick Start Guide
OPERATING THE PROJECTOR
Digital Projection Ltd. M-Vision WUXGA Series
Notes
See "Remote Control" on
page 21 for full details of
how to adjust the lens using
the remote control.
Rev A January 2024
page 33
Advertisement
Table of Contents
