Table of Contents
Advertisement
Operating the projector
Control panel
1. POWER
Switches the projector on and
off (STANDBY).
2. SYNC
Press to resynchronise the
active input.
3. Arrow buttons & ENTER
Press Focus , Lens Shift or
Zoom and use the Up and
Down arrow buttons to adjust
the lens focus, shift or zoom.
After opening the OSD, use the
arrow buttons to highlight
menu entries. Press ENTER to
open or execute the
highlighted menu entry.
4. MENU
Press to display or hide the OSD menu.
5. MUTE
Shows and hides the projected image.
There are two shutter settings:
Laser. When closed, the laser is switched off and no image is projected
l
DMD™ Blanking. When closed, the laser remains on and a black image
l
is projected
6. OSD
Press to enable or disable the OSD. When disabled, the OSD cannot be
displayed.
7. FOCUS
Press this button, then press an arrow button to adjust the focus. Press EXIT to
exit the focus mode.
8. LENS SHIFT
Press this button, then press an arrow button to adjust the lens shift. Press EXIT
to exit the lens shift mode. Press and hold for 5 seconds to center the lens.
9. INPUT
Press to move to the next input source.
Important Information
Digital Projection Ltd.
M-Vision 2X000 Series WUXGA
1
2
3
4
5
6
7
8
Control Panel
9
Rev A December 2023
page 51
Advertisement
Table of Contents
