Disassemble The Chassis For Recycle - Lenovo ThinkSystem SD530 V3 User Manual

13. If the PCIe riser assembly is installed, remove it from the node and disconnect the PCIe cables from the
system board (see "Remove the PCIe riser assembly" on page 116
routing" on page 173).
14. Remove the power bus bar (see
15. Disconnect the power distribution board cables from the system board; then, remove the power
distribution board (see
16. If the rear OCP and rear I/O module cables are connected to the system board, remove them (see
I/O and OCP module cable routing" on page
17. Remove the rear I/O module (see
18. Remove all the installed cable ducts.
19. Disconnect all the cables from the system board.
20. Remove the system board (see

Disassemble the chassis for recycle

Follow instructions in this section to disassemble the ThinkSystem D3 Chassis before recycling the chassis.
About this task
Attention:
• Read "Installation Guidelines" on page 41
you work safely.
Step 1. Power off all the nodes (see
from the nodes.
Step 2. Remove all the nodes from the chassis (see
Step 3. Remove all power supply units and PSU fillers from the PSU cage (see
supply" on page 58
Step 4. Remove the chassis from the rack (see
the chassis on a flat, static-protective surface.
Step 5. Remove the PSU cage from the chassis (see
Step 6. Remove the chassis midplane from the PSU cage (see
67).
Step 7. Remove the left and right EIA brackets from the chassis (see
chassis " on page
After disassembling the chassis, recycle the units in compliance with local regulations.
ThinkSystem SD530 V3 User Guide
234
"Remove the power bus bar" on page
"Remove the power distribution board" on page
179).
"Remove the rear I/O module" on page
"Remove the system board (Trained technician only)" on page
and "Safety inspection checklist" on page 42
"Power off the node" on page
and Removal of a PSU
"Remove the chassis from the rack" on page
56).
and Chapter 6 "Internal cable
123).
127).
51); then, disconnect all external cables
"Remove a node from the chassis" on page
filler).
"Remove the PSU cage" on page
"Remove the chassis midplane" on page
"Remove the EIA brackets from the
148).
155).
to make sure that
72).
"Remove a hot-swap power
52); then, lay
64).
"Rear