Table of Contents
Advertisement
Memory mirroring mode installation order
Memory-mirroring mode provides full memory redundancy while reducing the total node memory capacity in
half. Memory channels are grouped in pairs with each channel receiving the same data. If a failure occurs, the
memory controller switches from the DIMMs on the primary channel to the DIMMs on the backup channel.
The DIMM installation order for memory mirroring varies based on the number of processors and DIMMs
installed in the node.
Memory mirroring guidelines:
• Memory mirroring reduces the maximum available memory by half of the installed memory. For example, if
the node has 64 GB of installed memory, only 32 GB of addressable memory is available when memory
mirroring is enabled.
• Each DIMM must be identical in size and architecture.
• DIMMs on each memory channel must be of equal density.
• If two memory channels have DIMMs, mirroring occurs across two DIMMs (channels 0/1 will both contain
the primary/secondary memory caches).
• If three memory channels have DIMMs, mirroring occurs across all three DIMMs (channels 0/1, channels
1/2, and channels 2/0 will all contain primary/secondary memory caches).
• Partial Memory Mirroring is a sub-function of memory mirroring. It requires following the memory
installation order of memory mirroring mode.
With one processor
The following table shows the DIMM population sequence for memory mirroring when one processor is
installed.
Table 21. Memory Mirroring with one processor
Total DIMMs
8†‡
Note:
† Sub NUMA Clustering (SNC2) feature can only be enabled when DIMMs are populated in this specified sequence. The
SNC2 feature can be enabled via UEFI.
‡ DIMM configurations that support Software Guard Extensions (SGX), see
on page 190
to enable this feature.
With two processors
The following table shows the DIMM population sequence for memory mirroring mode when two processors
are installed.
Table 22. Memory mirroring with two processors
Total DIMMs
8†‡
Total DIMMs
16†‡
ThinkSystem SD530 V3 User Guide
50
8
7
6
8
7
6
8
7
6
8
7
6
9
10
11
9
10
11
Processor 1
5
4
5
4
"Enable Software Guard Extensions (SGX)"
Processor 1
5
4
5
4
Processor 2
12
13
12
13
3
2
3
2
3
2
3
2
14
15
14
15
1
1
1
1
16
16
Advertisement
Table of Contents
Troubleshooting
