Figure 102. Installation of a 1U Standard PHM for two-processor configuration
Figure 103. Installation of a 1U Performance PHM for two-processor configuration
After this task is completed
1. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see
"Install the top cover" on page
2. Reinstall the node into the chassis (see
3. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
51.)
4. Proceed to complete the parts replacement (see
170).
"Install a node to the chassis" on page
"Install a hot-swap power supply" on page 61
and
"Complete the parts replacement" on page
.
Chapter 5
Hardware replacement procedures
75).
"Power on the node" on page
171).
147