Table of Contents
Advertisement
Figure 63. Memory modules and processors layout
Step 2.
Touch the static-protective package that contains the memory module to any unpainted surface on
the outside of the node. Then, take the memory module out of the package and place it on a static-
protective surface.
Step 3.
Install the memory module into the slot.
a.
Open the retaining clip at teach end of the memory module slot.
b.
Align the memory module with the slot and gently place the memory module into the slot
with both hands.
c.
Firmly press both ends of the memory module straight down into the slot until the retaining
clips snap into the locked position.
Attention:
• To avoid breaking the retaining clips or damaging the DIMM connectors, handle the retaining
clips gently.
• If there is a gap between the memory module and the retaining clips, the memory module has
not been correctly inserted. In this case, open the retaining clips, remove the memory module,
and then reinsert it.
.
Chapter 5
Hardware replacement procedures
109
Advertisement
Table of Contents
Troubleshooting
