Lenovo ThinkSystem SD530 V3 User Manual page 100

a. Power off the node (see
from the node.
b. Remove the node from the chassis (see
carefully lay the node on a flat, static-protective surface, orienting the node with the front
toward you.
Notes:
• When removing the node, note the node tray number and make sure to install the node in
the same tray from which it was removed. Reinstalling the node into a different tray requires
the node to be reconfigured.
• For safety, make sure to hold the node with both hands when lifting the node.
c. Remove the top cover (see
d. If the GPU air duct is installed in the node, remove it (see
91).
Step 2. Identify the fan to be removed; then, remove the fan from the fan cage.
a. Pull out the four rivets that secure the fan to the fan cage on the top side.
b. Press and hold the fan cable latch.
c. Disconnect the fan cable from the system board.
d. Lift the fan out of the fan cage.
Figure 46. Fan removal
After this task is completed
1. Install a replacement unit (see
Important: To maintain proper cooling, all the fans must be installed during operation.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a fan
Follow instructions in this section to install a fan.
About this task
To avoid potential danger, make sure to read and follow the safety information.
ThinkSystem SD530 V3 User Guide
90
"Power off the node" on page
"Remove a node from the chassis" on page
"Remove the top cover" on page
"Install a fan" on page 90).
51); then, disconnect all external cables
168).
"Remove the GPU air duct" on page
72); then,