Lenovo ThinkSystem SD530 V3 User Manual page 98

3. Reinstall the node into the chassis (see
4. Reinstall all drives and drive fillers (if any) to the node (see
5. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
51.)
6. Proceed to complete the parts replacement (see
Install a drive cage assembly
Follow instructions in this section to install a drive cage assembly.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read "Installation Guidelines" on page 41
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node and chassis; then, take the component out of the package and place it on a static-protective
surface.
Procedure
Step 1. If the drive backplane has not been installed yet, install it to the drive cage; then, reconnect all the
required cables to the drive backplane (see
"Install a drive backplane" on page
Step 2. Install the drive cage assembly to the node.
a. Lower the cage into the node until all the screw holes are aligned.
b. Tighten the seven screws to secure the cage.
ThinkSystem SD530 V3 User Guide
88
"Install a node to the chassis" on page
"Install a hot-swap power supply" on page 61
and "Safety inspection checklist" on page 42
87).
"Install a hot-swap drive" on page
and
"Complete the parts replacement" on page
"E3.S drive backplane cable routing" on page 176
75).
97).
"Power on the node" on page
171).
to make sure that
and