Table of Contents
Advertisement
• If you are replacing a processor and reusing the heat sink, remove the processor
identification label from the heat sink and replace it with the new label that comes with the
replacement processor.
• If you are replacing a heat sink and reusing the processor, remove the processor
identification label from the old heat sink and place it on the new heat sink in the same
location.
Note: If you are unable to remove the label and place it on the new heat sink, or if the label
is damaged during transfer, write the processor serial number from the processor
identification label on the new heat sink in the same location as the label would be placed
using a permanent marker.
Step 2.
Install the processor in the new carrier.
Notes:
• If you are replacing the processor and reusing the heat sink, use the new carrier that comes with
the new processor.
• If you are replacing the heat sink and reusing the processor, and if the new heat sink comes with
two processor carriers, make sure to use the same type of carrier as the one you discarded.
1.
Make sure the handle on the carrier is in the closed position.
2.
Align the processor on the new carrier so that the triangular marks align; then, insert the
marked end of the processor into the carrier.
3.
Hold the inserted end of the processor in place; then, pivot the unmarked end of the carrier
down and away from the processor.
4.
Press the processor and secure the unmarked end under the clip on the carrier.
5.
Carefully pivot the sides of the carrier down and away from the processor.
6.
Press the processor and secure the sides under the clips on the carrier.
Note: To prevent the processor from falling out of the carrier, keep the processor-contact side
up and hold the processor-carrier assembly by the sides of the carrier.
ThinkSystem SD530 V3 User Guide
140
Advertisement
Table of Contents
Troubleshooting
