Table of Contents
Advertisement
Figure 104. Removal of the rear I/O cable and grounding cable
Step 3.
Remove the rear I/O module.
a.
Remove the three screws from the rear I/O module as illustrated.
b.
Slightly pull the rear I/O module toward the front of the node; then, lift it out of the node.
Figure 105. Removal of the rear I/O module
After this task is completed
1. Install a replacement unit (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
"Install a rear I/O module" on page
150).
.
Chapter 5
Hardware replacement procedures
149
Advertisement
Table of Contents
Troubleshooting
