Lenovo ThinkSystem SD530 V3 User Manual page 124

Note: If necessary, use a screwdriver for this step.
b. Grasp the handle and pull out the OCP module.
Figure 69. Removal of the rear OCP module
After this task is completed
1. Install a replacement unit or filler (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install an OCP module
Follow instructions in this section to install an OCP module.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read "Installation Guidelines" on page 41
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node and chassis; then, take the component out of the package and place it on a static-protective
surface.
• Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
– Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sd530v3/7dd3/downloads/
driver-list to see the latest firmware and driver updates for your server.
ThinkSystem SD530 V3 User Guide
114
"Install an OCP module" on page
and "Safety inspection checklist" on page 42
114).
to make sure that