Lenovo ThinkSystem SD530 V3 User Manual page 170

After this task is completed
1. Install a replacement unit (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Important: Before returning the system board, make sure to install the processor socket covers from
the new system board. Follow the steps below to replace a processor socket cover:
a. Take a socket cover from the processor socket assembly on the new system board and orient it
correctly above the processor socket assembly on the removed system board.
b. Gently press down the socket cover legs to the processor socket assembly, pressing on the edges to
avoid damage to the socket pins. You might hear a click on the socket cover when it is securely
attached.
c. Make sure that the socket cover is securely attached to the processor socket assembly.
Install a system board (Trained technician only)
Follow instructions in this section to install a system board.
About this task
Important: This task must be operated by trained technicians that are certified by Lenovo Service. Do no
attempt to remove or install it without proper training and qualification.
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read "Installation Guidelines" on page 41
you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• After replacing the system board, always update the server with the latest firmware or restore the pre-
existing firmware.
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sd530v3/7dd3/downloads/driver-
to see the latest firmware and driver updates for your server.
list
• Go to "Update the firmware" on page 185
Procedure
Step 1. Install the system board to the node.
Important: When installing the system board into the node, avoid touching the connectors on the
system board. Do not damage any surrounding components inside the node.
a. Carefully hold the rear edge of the system board and tilt the system board at angle.
b. Align the connectors of the system board and the front of the node; then, gently slide and
insert the system board into place.
c. Carefully seat the system board onto the corresponding guide pins and screw holes in the
node.
ThinkSystem SD530 V3 User Guide
160
"Install a system board (Trained technician only)" on page
and "Safety inspection checklist" on page 42
for more information on firmware updating tools.
160).
to make sure that