Lenovo ThinkSystem SD530 V3 User Manual page 164

Procedure
Step 1. Touch the static-protective package that contains the component to any unpainted metal surface
on the node and chassis; then, take the component out of the package and place it on a static-
protective surface.
Step 2. Locate the Firmware and RoT security module connector on the system board.
Figure 110. Location of the Firmware and RoT security module
Step 3. Install the firmware and RoT security module to the node.
a. Lower the firmware and RoT security module onto the system board and make sure that the
connector on the module is correctly inserted into the slot on the system board.
b. Tighten the two screws to secure the firmware and RoT security module.
Figure 111. Installation of the firmware and RoT security module
After this task is completed
1. Reconnect all the required cables to the drive backplane; then, reinstall the drive cage assembly to the
node (see "E3.S drive backplane cable routing" on page 176
page 88).
2. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see "Install the top cover" on page
ThinkSystem SD530 V3 User Guide
154
170).
and "Install a drive cage assembly" on