Lenovo ThinkSystem SD530 V3 User Manual page 97

After this task is completed
1. Install a replacement unit (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a drive backplane
Follow instructions in this section to install a drive backplane.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read "Installation Guidelines" on page 41
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node and chassis; then, take the component out of the package and place it on a static-protective
surface.
Procedure
Step 1. Make preparations for this task.
a. Remove the drive cage assembly from the node and place it on a flat, static-protective surface
(see "Remove the drive cage assembly" on page
Step 2. Install the drive backplane.
a. Align the drive backplane with the corresponding guide pins on the drive cage; then, lower
and insert the drive backplane into place.
b. Tighten the screws to secure the drive backplane.
Figure 44. Installation of the drive backplane
After this task is completed
1. Reconnect all the required cables to the drive backplane; then, reinstall the drive cage assembly to the
node (see "E3.S drive backplane cable routing" on page 176
page 88).
2. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see "Install the top cover" on page
"Install a drive backplane" on page
and "Safety inspection checklist" on page 42
170).
87).
84).
and "Install a drive cage assembly" on
.
Chapter 5 Hardware replacement procedures
to make sure that
87