Table of Contents
Advertisement
Figure 112. Heat sink support bracket replacement
Step 3.
Disconnect all the cables from the system board. When disconnecting the cables, make a list of
each cable and record the connectors the cables are connected to, and use the record as a cabling
checklist after installing the new system board.
Step 4.
Remove all the installed cable ducts.
a.
Disengage the clips of the cable ducts from the node.
b.
Lift the cable ducts out of the node.
Figure 113. Cable duct replacement (one processor configuration)
.
Chapter 5
Hardware replacement procedures
157
Advertisement
Table of Contents
Troubleshooting
