Table of Contents
Advertisement
After disassembling the processor and memory expansion tray, comply with local regulations when
recycling.
Disassemble the server for chassis recycle
Follow the instructions in this section to disassemble the server before recycling the chassis.
Before disassembling the server:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
3. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack.
Complete the following steps to disassemble the server for chassis recycle:
Step 1.
Remove the security bezel (see
Step 2.
Remove the top cover (see
Step 3.
Remove both power supply units (see
Step 4.
Remove the processor and memory expansion tray and the expansion tray air baffle (see
the processor and memory expansion tray" on page
Step 5.
Remove the fan cage assembly (see
Step 6.
Remove all the drives that are installed (see
Step 7.
Remove both the drive backplanes that are installed (see
Step 8.
Remove the front VGA assembly (see
Step 9.
Remove the operator panel tray assembly (see
Step 10. Remove the PCIe riser-card assembly (see
Step 11. Remove all the adapters that are installed (see
LOM adapter" on page
Step 12. Remove the memory modules that are installed on the system board (see
module" on page
Step 13. Remove both PHMs that are installed on the system board (see
sink" on page
Step 14. Remove the system board (see
After disassembling the server, comply with local regulations when recycling the chassis.
49).
11).
"Remove the security bezel" on page
"Remove the top cover" on page
"Remove the fan cage assembly" on page
"Remove the front VGA assembly" on page
69).
77).
101).
"Remove the system board" on page
"Safety" on page iii
133).
"Remove a hot-swap power supply unit" on page
110).
"Remove a 2.5-inch hot-swap drive" on page
"Remove a drive backplane" on page
"Remove the front operator panel" on page
"Remove the PCIe riser-card assembly" on page
"Remove an adapter" on page 91
Appendix A. Hardware disassembling for recycle
and
"Installation
116).
59).
64).
and
"Remove the
"Remove a memory
"Remove a processor and heat
118).
94).
"Remove
53).
52).
86).
87).
163
Advertisement
Table of Contents
