Lenovo ThinkSystem SD530 V3 User Manual page 142

Heat sink
1
Heat sink triangular mark
2
Processor identification label
3
Nut and wire bail retainer
4
Torx T30 nut
5
Anti-tilt wire bail
6
Processor carrier
7
Clips to secure carrier to heat sink
8
Procedure
Step 1. Make preparations for this task.
a. Power off the node (see
from the node.
b. Remove the node from the chassis (see
carefully lay the node on a flat, static-protective surface, orienting the node with the front
toward you.
Notes:
• When removing the node, note the node tray number and make sure to install the node in
the same tray from which it was removed. Reinstalling the node into a different tray requires
the node to be reconfigured.
• For safety, make sure to hold the node with both hands when lifting the node.
c. Remove the top cover (see
d. For one-processor configuration, remove the 1U standard heat sink or 1U performance heat
sink that is installed on the front of the node.
Figure 85. PHM location for one-processor configuration
e. For two-processor configuration, remove the 1U standard heat sink that is installed on the
front of the node, or the 1U performance heat sink that is installed on the rear of the node.
ThinkSystem SD530 V3 User Guide
132
Clips to secure processor in carrier
9
Processor ejector handle
10
Carrier triangular mark
11
Processor heat spreader
12
Thermal grease
13
Processor contacts
14
Processor triangular mark
15
"Power off the node" on page
"Remove a node from the chassis" on page
"Remove the top cover" on page
51); then, disconnect all external cables
168).
72); then,