Lenovo ThinkSystem SD530 V3 User Manual page 121

Attention: Read "Installation Guidelines" on page 41
sure that you work safely.
Procedure
Step 1. Make preparations for this task.
a. Power off the node (see
from the node.
b. Remove the node from the chassis (see
carefully lay the node on a flat, static-protective surface, orienting the node with the front
toward you.
Notes:
• When removing the node, note the node tray number and make sure to install the node in
the same tray from which it was removed. Reinstalling the node into a different tray requires
the node to be reconfigured.
• For safety, make sure to hold the node with both hands when lifting the node.
c. Remove the top cover (see
d. Disconnect all the cables from the drive backplane; then, remove the drive cage assembly from
the node and place it on a flat, static-protective surface (see
assembly" on page
Step 2. Locate the MicroSD socket on the system board.
Figure 65. Location of the MicroSD socket
Step 3. Remove the MicroSD card.
a. Slide the socket lid to the open position.
b. Lift open the socket lid.
c. Remove the MicroSD card from the socket.
and
"Power off the node" on page
"Remove a node from the chassis" on page
"Remove the top cover" on page
84).
"Safety inspection checklist" on page 42
51); then, disconnect all external cables
168).
"Remove the drive cage
.
Chapter 5 Hardware replacement procedures
to make
72); then,
111