Appendix A. Hardware Disassembling For Recycle; Disassemble The Server For Chassis Recycle - Lenovo ThinkSystem SR860 V2 Maintenance Manual

Appendix A. Hardware disassembling for recycle

Follow the instructions in this section to recycle components with compliance with local laws or regulations.

Disassemble the server for chassis recycle

Follow the instructions in this section to disassemble the server before recycling the chassis.
About this task
Attention:
• Go over "Installation Guidelines" on page 137
• Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Step 1. Remove all the installed drives and fillers (see
and "Remove a 7mm drive" on page
Step 2. Remove all the installed power supply units and fillers (see
on page 199).
Step 3. Remove the top cover (see
Step 4. Remove both PCIe riser cages or fillers, the chassis air baffle, and the PCIe expansion tray (see
"Remove a 4U PCIe riser cage" on page
"Remove the 4U PCIe expansion tray" on page
Step 5. Remove the system board air baffle (see
processor and memory expansion tray and the expansion tray air baffle (see
processor and memory expansion tray" on page
Step 6. Remove the fan cage assembly (see
Step 7. Remove the LCD diagnostics panel (see
Step 8. Remove the USB front panel module (see
Step 9. Remove the front VGA assembly (see
Step 10. Remove the PCIe riser card assembly (see
Step 11. Remove all the adapters that are installed on the system board (see
188 and "Remove the OCP Ethernet adapter" on page
Step 12. Remove the memory modules that are installed on the system board (see
module" on page
Step 13. Remove both PHMs that are installed on the system board (see
sink" on page
Step 14. Remove the power backplane from the system board (see
194).
Step 15. Remove the system board (see
After disassembling the server, recycle the unit in compliance with local regulations.
© Copyright Lenovo 2020, 2022
12).
263).
"Remove the top cover" on page
"Remove the fan cage assembly" on page
"Remove the front VGA assembly" on page
179).
206).
"Remove the system board" on page
to ensure that you work safely.
"Remove a 2.5-inch hot-swap drive" on page 140
"Remove a hot-swap power supply unit"
240).
255, "Remove the chassis air baffle" on page
249).
"Remove the system board air baffle" on page
219).
"Remove the LCD diagnostics panel" on page
"Remove the USB front panel module" on page
"Remove the PCIe riser assembly" on page
184).
"Remove the power backplane" on page
270, and
"Remove the
153).
173).
161).
186).
"Remove an adapter" on page
"Remove a memory
"Remove a processor and heat
229).
226) or the
244).
315