Lenovo ThinkSystem SD530 V3 User Manual page 139

After this task is completed
1. Install a replacement unit (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a power distribution board
Follow instructions in this section to install a power distribution board.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read "Installation Guidelines" on page 41
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node and chassis; then, take the component out of the package and place it on a static-protective
surface.
Procedure
Step 1. Install the power distribution board.
a. Align the screws holes on the power distribution board with the screw holes on the node;
then, lower and insert the power distribution board into place.
b. Tighten the five screws to secure the power distribution board to the node.
Note: Make sure that the standoffs are securely seated in the holes of the power distribution
board.
Figure 83. Installation of a power distribution board
"Install a power distribution board" on page
and "Safety inspection checklist" on page 42
129.)
.
Chapter 5 Hardware replacement procedures
to make sure that
129