Install a rear I/O module
Follow instructions in this section to install a rear I/O module.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
• Read
"Installation Guidelines" on page 41
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node and chassis; then, take the component out of the package and place it on a static-protective
surface.
Procedure
Step 1.
Install the rear I/O module to the node.
a.
Align the screw holes on the rear I/O module with the screw holes on the bottom of the
node; then, lower the rear I/O module and slightly push it toward the rear into place.
b.
Tighten the three screws as illustrated to secure the rear I/O module.
Note: Make sure that the standoffs are securely seated in the holes of the rear I/O module as
illustrated.
Figure 106. Installation of the rear I/O module
Step 2.
Reconnect the cables to the rear I/O module.
a.
Route and connect the cable between the rear I/O module and the system board (see
I/O and OCP module cable routing" on page
ThinkSystem SD530 V3 User Guide
150
and
"Safety inspection checklist" on page 42
179).
to make sure that
"Rear