Lenovo ThinkSystem SD530 V3 User Manual page 111

b. Remove the node from the chassis (see
carefully lay the node on a flat, static-protective surface, orienting the node with the front
toward you.
Notes:
• When removing the node, note the node tray number and make sure to install the node in
the same tray from which it was removed. Reinstalling the node into a different tray requires
the node to be reconfigured.
• For safety, make sure to hold the node with both hands when lifting the node.
c. Remove the top cover (see
d. Disconnect all the cables from the drive backplane; then, remove the drive cage assembly from
the node and place it on a flat, static-protective surface (see
assembly" on page
e. Locate the M.2 connectors on the system board.
Figure 56. Location of the M.2 bays on the system board
M.2 bay 0
1
Step 2. Remove the M.2 drive from the system board.
a. Slightly press the retainer away from the M.2 drive to disengage the M.2 drive.
b. Pivot the rear side of the M.2 drive slightly away from the system board.
c. Pull the M.2 drive out of the connector at an angle of approximately 15 degrees.
Figure 57. Removal of an M.2 drive
"Remove a node from the chassis" on page
"Remove the top cover" on page
84).
168).
"Remove the drive cage
M.2 bay 1
2
.
Chapter 5 Hardware replacement procedures
72); then,
101