Lenovo ThinkSystem SD530 V3 User Manual page 114

Figure 59. Location of the M.2 bays on the system board
M.2 bay 0
1
Step 2. Install the M.2 drive to the system board.
a. Insert the M.2 drive into the M.2 connector at an angle of approximately 15 degrees.
b. Slightly press the retainer to accommodate the M.2 drive.
c. Pivot and press down the M.2 drive; then, make sure the M.2 drive is engaged securely by
the retainer.
Figure 60. Installation of an M.2 drive
After this task is completed
1. Reconnect all the required cables to the drive backplane; then, reinstall the drive cage assembly to the
node (see "E3.S drive backplane cable routing" on page 176
page 88).
2. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see "Install the top cover" on page
3. Reinstall the node into the chassis (see
4. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
51.)
5. Proceed to complete the parts replacement (see
ThinkSystem SD530 V3 User Guide
104
170).
"Install a node to the chassis" on page
"Install a hot-swap power supply" on page 61
M.2 bay 1
2
and "Install a drive cage assembly" on
and
"Complete the parts replacement" on page
75).
"Power on the node" on page
171).