Lenovo ThinkSystem SD530 V3 User Manual page 147

Figure 92. Separating a processor carrier the from heat sink
Note: The processor carrier will be discarded and replaced with a new one.
After you finish
1. Install the PHM (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a processor and heat sink
This task has instructions for installing an assembled processor and heat sink, known as a processor-heat-
sink module (PHM). This task requires a Torx T30 driver. This procedure must be executed by a trained
technician.
Important: This task must be operated by trained technicians.
"Install a processor and heat sink" on page 137).
.
Chapter 5 Hardware replacement procedures
137