Lenovo ThinkSystem SD530 V3 User Manual page 149

Greater than 185-watt, less or equal
to 205-watt
Greater than 205-watt
The following illustration shows the components of the PHM.
Figure 93. PHM components
Heat sink
1
Heat sink triangular mark
2
Processor identification label
3
Nut and wire bail retainer
4
Torx T30 nut
5
Anti-tilt wire bail
6
Processor carrier
7
Clips to secure carrier to heat sink
8
Procedure
Step 1. Make preparations for this task.
a. Record the processor identification label.
• Processor 1: Performance heat
sink
• Processor 2: N/A
• Processor 1: Performance heat
sink
• Processor 2: N/A
Clips to secure processor in carrier
9
Processor ejector handle
10
Carrier triangular mark
11
Processor heat spreader
12
Thermal grease
13
Processor contacts
14
Processor triangular mark
15
• Processor 1: Standard heat sink
• Processor 2: Performance heat
sink
• Processor 1: N/A
• Processor 2: N/A
.
Chapter 5 Hardware replacement procedures
139