Lenovo ThinkSystem SD530 V3 User Manual page 102

To avoid potential danger, make sure to read and follow the safety information.
Attention: Read "Installation Guidelines" on page 41
sure that you work safely.
Procedure
Step 1. Make preparations for this task.
a. Power off the node (see
from the node.
b. Remove the node from the chassis (see
carefully lay the node on a flat, static-protective surface, orienting the node with the front
toward you.
Notes:
• When removing the node, note the node tray number and make sure to install the node in
the same tray from which it was removed. Reinstalling the node into a different tray requires
the node to be reconfigured.
• For safety, make sure to hold the node with both hands when lifting the node.
c. Remove the top cover (see
Step 2. Remove the GPU air duct.
a. Loosen the screw that secures the GPU air duct.
b. Hold the edges of the GPU air duct; then, lift the GPU air duct out of the node.
Figure 48. Removal of the GPU air duct
After this task is completed
1. Install a replacement unit (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
ThinkSystem SD530 V3 User Guide
92
and "Safety inspection checklist" on page 42
"Power off the node" on page
"Remove a node from the chassis" on page
"Remove the top cover" on page
"Install a GPU air duct" on page
51); then, disconnect all external cables
168).
93).
to make
72); then,