Otto Bock Genium 3B1-3 Instructions For Use Manual page 12

CAUTION
Mechanical stress on the product
> Falling due to unexpected product behaviour as the result of a malfunction.
> Falling due to breakage of load-bearing components.
> Skin irritation due to defects on the hydraulic unit with leakage of liquid.
Do not subject the product to mechanical vibrations or impacts.
►
Check the product for visible damage before each use.
►
CAUTION
Use of the product when battery charge level is too low
Falling due to unexpected behaviour of the prosthesis because of changed damping behaviour.
Check the current charge level before use and charge the prosthesis if required.
►
Note that the operating time of the product may be reduced at low ambient temperatures or
►
due to ageing of the battery.
CAUTION
Risk of pinching in the joint flexion area
Injuries due to pinching of body parts.
Ensure that fingers/body parts or soft tissue of the residual limb are not in this area when
►
bending the joint.
CAUTION
Penetration of dirt and humidity into the product
> Falling due to unexpected product behaviour as the result of a malfunction.
> Falling due to breakage of load-bearing components.
Ensure that no solid particles or foreign objects can penetrate into the product.
►
The knee joint is weatherproof but not corrosion-resistant. Therefore, the knee joint should
►
not come into contact with salt water, chlorinated water or other solutions (such as soap or
shower gel, and body and/or wound fluids). Do not use the knee joint under extreme condi­
tions like diving or jumping into water. The knee joint is not designed for prolonged under­
water use or prolonged diving.
After contact with water, remove the Protective Cover (if installed) and hold the prosthesis
►
with the sole of the foot facing up until the water has drained from the knee joint and tube
adapter. Dry the knee joint and components with a lint-free cloth and allow the components
to fully air dry.
Should the knee joint or tube adapter come into contact with salt water, chlorinated water
►
or other solutions (such as soap or shower gel, and body and/or wound fluids), promptly
remove the Protective Cover (if installed) and clean the knee joint. In order to do so, rinse
the knee joint, tube adapter and Protective Cover with fresh water and let them dry.
In case of a malfunction after drying, the knee joint and tube adapter must be inspected by
►
an authorised Ottobock Service Center. The O&P professional is your contact.
The knee joint is not resistant to penetration from water jets or steam.
►
CAUTION
Signs of wear and tear on the product components
Falling due to damage or malfunction of the product.
Regular service inspections (maintenance) are mandatory in the interest of your own safety
►
and in order to maintain operating reliability and protect the warranty.
12