Information On The Power Supply/Battery Charging; Battery Charger Information - Otto Bock Genium 3B1-3 Instructions For Use Manual

CAUTION
Use of unapproved accessories
> Falling due to product malfunction as a result of reduced interference resistance.
> Interference of other electronic devices due to increased emissions.
Use the product only in combination with the accessories, signal converters and cables lis­
►
ted in the sections "Scope of delivery" (see page 19) and "Accessories" (see page 19).
NOTICE
Improper product care
Damage to the product due to the use of incorrect cleaning agents.
Clean the product with a damp cloth only (fresh water).
►
INFORMATION
Knee joint movement noise
When using exoprosthetic knee joints, servomotor, hydraulic, pneumatic or brake load depend­
ent control functions can cause movement noises. This kind of noise is normal and unavoidable.
It generally does not indicate any problems. If movement noise increases noticeably during the
lifecycle of the knee joint, the knee joint should be inspected by the O&P professional immedi­
ately.

4.4 Information on the Power Supply/Battery Charging

CAUTION
Charging the product without taking it off
Falling due to unexpected product behaviour because of changed damping behaviour.
For safety reasons, take the product off before charging the battery.
►
CAUTION
Charging the product with damaged power supply unit/charger/charger cable
Falling due to unexpected behaviour of the product caused by insufficient charging.
Check the power supply unit, charger and charger cable for damage before use.
►
Replace any damaged power supply unit, charger or charger cable.
►
NOTICE
Use of incorrect power supply unit/battery charger
Damage to product due to incorrect voltage, current or polarity.
Use only power supply units/battery chargers approved for this product by Ottobock (see
►
instructions for use and catalogues).

4.5 Battery charger information

WARNING
Storing/transporting the product near active implanted systems
Interference with active implantable systems (e.g. pacemaker, defibrillator, etc.) due to the
product's magnetic field.
When storing/transporting the product in the immediate vicinity of active implantable sys­
►
tems, ensure that the minimum distances stipulated by the manufacturer of the implant are
observed.
13