Paradyne Jetstream CPX-1000 Reference Manual page 121

1000-A2-GH30-00
Table 3–39.Retrieve STS1 Parameters and Description (Continued)
Parameter Parameter Type
exptrc
fepm BoolYN
gos
montype MonitoredType
trc
yelnc NotificationCode
pst PrimaryState
sst SecondaryState
February 2003
Description
This parameter indicates the expected path trace
content.
exptrc is a string of up to 64 ASCII characters and
is optional.
This parameter indicates whether the path
performance monitoring data will be aggregated
based on far-end block error (FEBE) indications. If
no value is specified, fepm defaults to "N".
fepm is optional.
This parameter indicates the grade of service. A
value of 0 means that grade of service is not
applied to the provisioned facility.
gos is an integer and optional.
This parameter indicates the Monitored Type.
montype is optional.
This parameter identifies the path trace message
to be transmitted. The trace byte continuously
transmits a 64 byte, fixed-length ASCII string, one
byte at a time. If no value is specified, trc defaults
to transmitting 62 null characters (hex 00) in
addition to CR and LF.
trc is a string and optional.
This parameter indicates the alarm status when a
yellow signal is detected. If no value is specified,
yelnc defaults to "Not Reported."
yelnc is optional.
This parameter indicates the primary state of the
entity.
pst is optional.
This parameter indicates the secondary state of
the entity.
3. TL1 Commands and Messages
3-73