Paradyne Jetstream CPX-1000 Reference Manual page 109

1000-A2-GH30-00
Table 3–32.Retrieve OC3 Parameters and Description
Parameter Parameter Type
oc_id
type Type
aisnc NotificationCode
dcc BoolYN
ferfnc NotificationCode
gos
sdh BoolYN
sfh BoolYN
February 2003
Description
This parameter specifies the AID for optical
carrier facility. oc_id is the AID OC and is listable
and rangeable. oc_id must not be null.
This parameter identifies the type of entity being
provisioned. Null indicates not applicable. This
parameter can be a common language equipment
identifier (CLEI) code or some other value.
type is optional.
This parameter indicates the alarm status when a
VT path AIS is detected. If no value is specified,
aisnc defaults to "not reported".
aisnc is optional.
This parameter indicates whether the section DCC
is used.
dcc is optional.
This parameter indicates the alarm status when a
far-end receive failure signal is detected. If no
value is specified, ferfnc defaults to "not alarmed
but reported."
ferfnc is optional.
This parameter indicates the grade of service. A
value of 0 means that grade of service is not
applied to the provisioned facility. Other positive
integers refer to a grade of service.
gos is an integer and optional.
This parameter establishes a high priority for the
OC in the event of a signal degrade. Default is N;
Y sets it to high.
sdh is optional.
This parameter establishes a high priority for the
OC in the event of a signal failure. Default is N; Y
sets it to high.
sfh is optional.
3. TL1 Commands and Messages
3-61