4.9.1.8 Factory Default
You can reset the configuration of the WGS-5225-8P2S Series on this page. Only the IP configuration is retained. The new
configuration is available immediately, which means that no restart is necessary. The Factory Default screen in
appears.
Buttons
: Click to reset the configuration to Factory Defaults.
: Click to return to the Port State page without resetting the configuration.
To reset the WGS-5225-8P2S Series to the Factory default setting, you can also press the hardware reset
button at the front panel about 10 seconds. After the device is rebooted, you can login the management
Web interface within the same subnet of 192.168.0.xx.
4.9.1.9 System Reboot
The Reboot page enables the device to be rebooted from a remote location. Once the Reboot button is pressed, user has to
re-login the Web interface about 60 seconds later; the System Reboot screen in
Buttons
: Click to reboot the system.
: Click to return to the Port State page without rebooting the system.
Figure 4-9-10: Factory Default Page Screenshot
Figure 4-9-11: System Reboot Page Screenshot
430
User's Manual of WGS-5225-8P2S Series
Figure 4-9-11
appears.
Figure 4-9-10