Factory Default - Planet IGS-10020HPT-U User Manual

The page includes the following fields:
Object
• Image
• Version
• Date
Buttons

4.9.1.8 Factory Default

You can reset the configuration of the Industrial Managed PoE+ Switch on this page. Only the IP configuration is retained. The
new configuration is available immediately, which means that no restart is necessary. The Factory Default screen in
4-9-1-10 appears.
Buttons
: Click to reset the configuration to Factory Defaults.
: Click to return to the Port State page without resetting the configuration.
To reset the Industrial Managed PoE+ Switch to the Factory default setting, you can also press the
hardware reset button on the front panel for about 10 seconds. After the device is rebooted, you can log in
the management Web interface within the same subnet of 192.168.0.xx.
Description
The flash index name of the firmware image. The name of primary (preferred)
image is image, the alternate image is named image.bk.
The version of the firmware image.
The date when the firmware was produced.
: Click to use the alternate image. This button may be disabled depending on system state.
Figure 4-9-1-10: Factory Default Page Screenshot
User's Manual of IGS-10020HPT-U
375
Figure