Factory Default - Planet IGS-5225 Series User Manual

In case the active firmware image is the alternate image, only the "Active Image" table is shown. In this
case, the Activate Alternate Image button is also disabled.
1.
2.
The page includes the following fields:
Object
• Image
• Version
• Date
Buttons

4.9.1.8 Factory Default

You can reset the configuration of the Industrial Managed Switch on this page. Only the IP configuration is retained. The new
configuration is available immediately, which means that no restart is necessary. The Factory Default screen in
If the alternate image is active (due to a corruption of the primary image or by manual
intervention), uploading a new firmware image to the device will automatically use the primary
image slot and activate this.
The firmware version and date information may be empty for older firmware releases. This does
not constitute an error.
Figure 4-9-1-9: Software Image Selection Page Screenshot
Description
The flash index name of the firmware image. The name of primary (preferred)
image is image, the alternate image is named image.bk.
The version of the firmware image.
The date when the firmware was produced.
: Click to use the alternate image. This button may be disabled depending on system state.
User's Manual of IGS-5225 series
433
Figure 4-9-1-10