Planet WGS-5225-8P2SV User Manual page 242

 Loopback Support
 Link Monitor Support
 MIB Retrieval Support
 Loopback Operation
Buttons
Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
DTE. This eliminates the possibility of passive to passive links. Passive
DTE's shall not send Variable Request or Loopback Control OAMPDUs.
Controls whether the loopback support is enabled for the switch port. Link OAM
remote loopback can be used for fault localization and link performance testing.
Enabling the loopback support will allow the DTE to execute the remote loopback
command that helps in the fault detection.
Controls whether the Link Monitor support is enabled for the switch port. On
enabling the Link Monitor support, the DTE supports event notification that permits
the inclusion of diagnostic information.
Controls whether the MIB Retrieval Support is enabled for the switch port. On
enabling the MIB retrieval support, the DTE supports polling of various Link OAM
based MIB variables' contents.
If the Loopback support is enabled, enabling this field will start a loopback operation
for the port.
242
User's Manual of WGS-5225-8P2S Series