Table of Contents
Advertisement
Before we connect the Wall-mount Managed Switch to the other network device, we have to make sure both sides of the
1.
SFP transceivers are with the same media type, for example, 1000BASE-SX to 1000BASE-SX, 1000BASE-LX to
1000BASE-LX.
Check whether the fiber-optic cable type matches with the SFP transceiver requirement.
2.
To connect to 1000BASE-SX SFP transceiver, please use the multi-mode fiber cable with one side being the male
duplex LC connector type.
To connect to 1000BASE-LX SFP transceiver, please use the single-mode fiber cable with one side being the male
duplex LC connector type.
Connect the Fiber Cable
Insert the duplex LC connector into the SFP transceiver.
1.
Connect the other end of the cable to a device with SFPtransceiver installed.
2.
Check the LNK/ACT LED of the SFP slot on the front of the Wall-mount Managed Switch. Ensure that the SFP
3.
transceiver is operating correctly.
Check the Link mode of the SFP port if the link fails. To function with some fiber-NICs or Media Converters, user has to
4.
set the port Link mode to "100M Force" or "1000M Force".
Remove the Transceiver Module
Make sure there is no network activity anymore.
1.
Remove the Fiber-Optic Cable gently.
2.
Lift up the lever of the MGB module and turn it to a horizontal position.
3.
Pull out the module gently through the lever.
4.
Never pull out the module without lifting up the lever of the module and turning it to a
horizontal position. Directly pulling out the module could damage the module and the SFP
module slot of the Wall-mount Managed Switch.
Figure 2-2-5: How to Pull Out the SFP Transceiver
40
User's Manual of WGS-5225-8P2S Series
Advertisement
Table of Contents
