Planet WGS-5225-8P2SV User Manual page 275

 2 Step Flag
 Ports
 Clock Identity
 Dom
 Clock Quality
 Pri1
 Pri2
 Local Prio
 Protocol
 VID
 PCP
 DSCP
This parameter applies only to a slave. In one-way mode no delay
measurements are performed, i.e. this is applicable only if frequency
synchronization is needed.
The master always responds to delay requests.
Static member: defined by the system, true if two-step Sync events and
Pdelay_Resp events are used
The total number of physical ports in the node
It shows unique clock identifier
Clock domain [0..127].
The clock quality is determined by the system, and holds 3 parts: Clock Class,
Clock Accuracy and OffsetScaledLog Variance as defined in IEEE1588.
The Clock Accuracy values are defined in IEEE1588 table 6 (Currently the clock
Accuracy is set to 'Unknown' as default).
Clock priority 1 [0..255] used by the BMC master select algorithm.
Clock priority 2 [0..255] used by the BMC master select algorithm.
Priority [1..255] used in the 8275.1 BMCA.
Transport protocol used by the PTP protocol engine
■ Ethernet PTP over Ethernet multicast
■ EthernetMixed PTP using a combination of Ethernet multicast and
unicast
■ IPv4Multi PTP over IPv4 multicast
■ IPv4Mixed PTP using a combination of IPv4 multicast and unicast
■ IPv4Uni PTP over IPv4 unicast
VLAN Identifier used for tagging the VLAN packets.
Priority Code Point value used for PTP frames.
DSCP value used when transmitting IPv4 encapsulated packets
275
User's Manual of WGS-5225-8P2S Series