Table of Contents
Advertisement
Reflector Port
Source VLAN(s)
Configuration
Remote Mirroring
Port Configuration
For a given port, a frame is only transmitted once. It is therefore not possible to mirror Tx frames on
the mirror port. Because of this, mode for the selected mirror port is limited to Disabled or Rx
only.
Buttons
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
The reflector port is a method to redirect the traffic to Remote Mirroring VLAN. Any
device connected to a port set as a reflector port loses connectivity until the Remote
Mirroring is disabled.
In the stacking mode, you need to select switch ID to select the correct device.
If you shut down a port, it cannot be a candidate for reflector port.
If you shut down the port which is a reflector port, the remote mirror function cannot
work
The switch can supports VLAN-based Mirroring. If you want to monitor some VLANs
on the switch, you can set the selected VLANs on this field.
The following table is used for port role selection.
Port: The logical port for the settings contained in the same row..
■
Source:
Select mirror mode.
■
Disabled Neither frames transmitted nor frames received are mirrored.
Both Frames received and frames transmitted are mirrored on the Destination
port.
Rx only Frames received on this port are mirrored on the Destination port.
Frames transmitted are not mirrored.
Tx only Frames transmitted on this port are mirrored on the Destination port.
Frames received are not mirrored
Destination: Select destination port.
■
This checkbox is designed for mirror or Remote Mirroring.
The destination port is a switched port that you receive a copy of traffic from
the source port.
118
User's Manual of WGS-5225-8P2S Series
Advertisement
Table of Contents
