Table of Contents
Advertisement
The Page includes the following fields:
Object
Username
Password
Password (again)
Privilege Level
Buttons
: Click to apply changes.
: Click to undo any changes made locally and revert to previously saved values.
: Click to undo any changes made locally and return to the Users.
: Delete the current user. This button is not available for new configurations (Add new user)
Once the new user is added, the new user entry is shown on the Users Configuration Page.
If you forget the new password after changing the default password, please press the "Reset"
button on the front panel of the Wall-mount Managed Switch for over 10 seconds and then release
it. The current setting including VLAN will be lost and the Wall-mount Managed Switch will restore
to the default mode.
Description
A string identifying the user name that this entry should belong to. The allowed
string length is 1 to 31. The valid user name is a combination of letters, numbers
and underscores.
The password of the user. The allowed string length is 1 to 31.
Please enter the user's new password here again to confirm.
The privilege level of the user.
The allowed range is 1 to 15. If the privilege level value is 15, it can access all
groups, i.e. that is granted the fully control of the device. But others value need
to refer to each group privilege level. User's privilege should be same or greater
than the group privilege level to have the access of that group.
Figure 4-2-7: User Configuration Page Screenshot
59
User's Manual of WGS-5225-8P2S Series
Advertisement
Table of Contents
