Adjustment; Adjusting The Seat Depth - Permobil Corpus 3G Service Manual

Adjustment

Adjustment

Adjusting the seat depth

The seat depth can be adjusted to suit different
users. There are nine fixed levels, each 25 mm apart.
Adjustment of the seat depth is performed by
mounting the front section of the Seat frame incl.
Leg rest and the rear section of the seat frame
incl. Back rest into desired positions according
to the table on 7 and 8. When the seat depth is
adjusted it may be necessary to replace cushions,
seat plates and UniTrack rails for ones of the
appropriate length. The mounting position for the
seat on the seat lift/fixed seat column may also
need adjusting. See 37.
1. Remove the seat cushion by lifting it straight
up. It is attached by means of Velcro on the
rear of the cushion.
2. Remove the seat plates, which are held in
place by two screws at the back edge and
two quick-mount clamps at the front. See the
illustration. First remove the screws, then use
your hand to carefully push the seat plate
from below to release the quick-mount clamps
at the front.
3. Remove the UniTrack rails which are each held
in place by two screws. See the illustration.
For this task the following tools are necessary:
1 Allen key 5 mm
The seat plates are held in place by two
screws at the back edge and two quick-mount
clamps at the front.
The UniTrack rails are fixed in place
with two screws each.
6
Adjusting the seat depth