Bluetooth Connection; Bluetooth On/Off - AEMC 607 User Manual

4.15.2 Bluetooth Connection

The following steps are for pairing using Windows 7.
1. In the active measurement function, press the
simultaneously. The
the display.
2. Connect the supplied Bluetooth USB Adapter into an available USB
port. Windows will install any necessary drivers automatically.
3. A Bluetooth symbol (similar to this:
the bottom of your screen once the driver is installed.
4. Right click on the icon and select Add a Device.
5. In the Add a Device window, select the instrument you wish to connect
and select Next.
NOTE:
Depending on the Bluetooth setup and operating system, it may
be necessary to enter a passkey to finalize the instrument connection.
If so, the default passkey is 0000.
6. If asked for a pairing code select Enter the Device's pairing code.
7. Enter the pairing code as shown below and select Next.
8. Once the instrument has been successfully added to the computer, a
window will be displayed. Select Close.
9. You should see the Device listed in the Bluetooth devices window.
10. Launch the DataView
icon in the DataView folder placed on the desktop during software
installation. Refer to § 4.21 for DataView
instrument should automatically connect if only one power meter is
paired. If more than one instrument is paired, select the instrument you
wish to connect to from the drop-down list in the connection window.
11. Selecting OK will establish the connection between the power meter
and the DataView
status and downloaded data. If data is present in the instrument's
memory, the software will automatically start downloading once
connected.

4.16 BLUETOOTH ON/OFF

Bluetooth can only be turned on or off when the instrument is not recording.
To enable the Bluetooth press the
symbol should appear in the upper right corner of the display. To disable
Bluetooth press the
OFF.
48
symbol will appear in the upper right corner of
PowerPad Control Panel by clicking the
®
software. It is now possible to view the instrument
®
and
and buttons simultaneously; the
Clamp-On Meter Model 607 - User Manual
and
) will appear in the system tray at
software installation. The
®
buttons simultaneously. The
buttons
symbol will turn