Balanced 3-Phase Power Measurement - AEMC 607 User Manual

4.10.2 Balanced 3-Phase Power Measurement

1. Set the switch to
2. Press the
3. The device automatically displays AC+DC. To select AC, DC, or
AC+DC, press the
4. Connect the black lead to the COM terminal and the red lead to
+
the terminal.
5. Connect the leads and the clamp to the circuit as follows:
If the red lead is
connected to...
L1 phase
L2 phase
L3 phase
NOTE:
The arrow on the jaws of the clamp (see the diagram below)
must point in the presumed direction of flow of the current from the
source (producer) to the load (consumer).
Clamp-On Meter Model 607- User Manual
.
button until the
button until the desired choice is reached.
...and the black lead is
connected to
L2 phase
L3 phase
L1 phase
symbol is displayed.
...then the clamp is on
the conductor of the
L3 phase
L1 phase
L2 phase
37