Table of Contents
Advertisement
1.2.9 Regeneration of exhaust gas aftertreatment system
1.2.10
Emergency procedures
1.2.10.1
Actuating the emergency stop switch
1.2.10.2
Disconnecting the battery
General – Concerning your safety
You should therefore always make sure that the filling system is
properly grounded and that there is equipotential bonding to the
machine. If necessary use a connecting cable between filling
system and vehicle ground.
Monitor the entire refuelling process.
Do not spill any fuel. Collect leaking fuel, do not let it seep into the
ground.
Wipe off spilled fuel. Keep dirt and water away from the fuel.
A leaking fuel tank can cause an explosion. Ensure tight fit of the
fuel tank cover, if necessary replace immediately.
During regeneration, the exhaust gas reaches very high tempera-
tures and the exhaust gas quantity increases - fire hazard!
Components of the exhaust gas aftertreatment system get very
hot.
Do not touch hot components or exhaust gases.
Ensure an adequate supply of fresh air.
Keep a safe distance to combustible or explosive materials.
When performing regeneration at standstill, park the machine out-
doors at a safe distance from any combustible or explosive mate-
rials.
In events of emergency and in case of danger actuate the emer-
gency stop switch immediately.
The machine is braked immediately, the engine is shut down.
Restart the machine only after the danger that caused the actua-
tion of the emergency stop switch has been eliminated.
In case of frequent use the wear on the multi-discs brakes will be
very high, you should therefore never use the emergency stop
switch as a service brake.
In events of emergency, e.g. in case of a cable fire, disconnect the
battery from the vehicle network.
Pull out the main battery switch or lift off the battery pole to do so.
BM 500/15
29
Advertisement
Table of Contents
