Table of Contents
Advertisement
General – Concerning your safety
1.2.8 Refuelling
1.2.9 Regeneration of exhaust gas aftertreatment system
28
Before leaving the machine:
n
shift all control levers to "Neutral position", "Off" or "0",
n
apply the parking brake,
n
shut down the engine, pull off the ignition key,
n
pull off the main battery switch,
n
secure the machine against unauthorized use.
Do not jump off the machine, but use hand grips and access steps.
Mark machines, which could be in the way, with a clearly visible
sign.
When parking on ascents or descents use appropriate means to
secure the machine against rolling.
Do not inhale any fuel fumes.
Refuel only with the engine shut down.
Do not refuel in closed rooms.
No open fire, do not smoke.
Static charges may be generated in the fuel as it passes through
the filling system. The discharge of these charges in the presence
of combustible vapours can cause fire or an explosion.
Ultra-low sulphur diesel fuel poses a higher risk of combustion
caused by the static charging than diesel fuel with a higher sulphur
content.
You should therefore always make sure that the filling system is
properly grounded and that there is equipotential bonding to the
machine. If necessary use a connecting cable between filling
system and vehicle ground.
Monitor the entire refuelling process.
Do not spill any fuel. Collect leaking fuel, do not let it seep into the
ground.
Wipe off spilled fuel. Keep dirt and water away from the fuel.
A leaking fuel tank can cause an explosion. Ensure tight fit of the
fuel tank cover, if necessary replace immediately.
During regeneration, the exhaust gas reaches very high tempera-
tures and the exhaust gas quantity increases - fire hazard!
Components of the exhaust gas aftertreatment system get very
hot.
Do not touch hot components or exhaust gases.
Ensure an adequate supply of fresh air.
Keep a safe distance to combustible or explosive materials.
BW 190/202 AD-5 / BW 190/202 ADO-5
Advertisement
Table of Contents
