Network Communication Setup - Xerox WorkCentre 7132 System Administration Manual

Test iFax
The iFax job should be submitted to make sure that the machine has been installed and
configured correctly.

Network Communication Setup

NOTE: Some of the configuration options for this protocol are only available from the
CentreWare Internet Services. Refer to the CentreWare Internet Services chapter of
the User Guide.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP
network.
Initially, activate the port.
1.
Connect the machine to the network.
2.
Display the [System Settings] screen.
NOTE: For more information about how to display the [System Settings] screen, refer
to the Setups chapter of the User Guide.
3.
Select [Network Settings].
4.
Select [Port Settings].
5.
Select [Receive E-mail] and then [Change Settings].
6.
Select [Port Status] and then [Change Settings].
7.
Select [Enabled] and then [Save].
8.
On the [Port Settings] screen, select [Send E-mail] and then [Change Settings].
9.
Select [Port Status] and then [Change Settings].
10.
Select [Enabled] and then [Save].
Next, establish TCP/IP.
1.
Display the [System Settings] screen.
NOTE: For more information about how to display the [System Settings], refer to the
Setups chapter of the User Guide.
2.
Select [Network Settings].
3.
Select [Protocol Settings].
4.
Select [TCP/IP - Get IP Address], and then [Change Settings].
Xerox WorkCentre 7132 System Administration Guide
iFax Installation
139