Netware - Xerox WorkCentre 7132 System Administration Manual

4 CentreWare Internet Services
• Auto Master Mode – Allows you to enable or disable (on/off) Auto Master Mode.
• Password Encryption – Allows you to enable or disable password encryption
5.
Select [Apply] to reflect the new setting.
6.
Enter the user ID and password then select [OK].
NOTE: The default user ID is "11111" and the default password is "x-admin".
7.
When the reboot message appears, select [Reboot Machine].
NOTE: For more information about the contents of items, refer to the CentreWare
Internet Services chapter of the User Guide.

NetWare

This page allows you to configure the NetWare settings for the following options.
NOTE: Some settings on this page will only be available after you restart CentreWare
Internet Services, or after the machine is switched off and on.
1.
At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2.
In the [Properties] frame, select the plus symbol [+] to the left of the [Protocol
Settings] folder.
3.
Select [NetWare].
4.
Set up the following options to be displayed in the frame.
General:
• Host Name – Enter the host name.
• Active Mode – Selects the Active Mode for the printer when using NetWare.
• File Server Name – Enter the file server name.
• Polling Interval – Allows you to set the time interval from when print data enter
• Number of Searches – Enter the maximum number of searches.
• Password – Enter the print server (PServer) password.
• Re-enter Password – Allows you to verify the PServer password by re-entering
• TBCP Filter – (Only available when the optional PostScript Kit is installed.)
NDS:
• Tree Name – Enter the tree name.
• Context Name – Enter the context name of the Print Server.
Transport Protocol (IPX/SPX):
• Frame Type – Select the frame type (Auto, Ethernet II, Ethernet 802.3, Ethernet
54
during SMB transmission.
the print queue until printing starts.
the same password.
802.2, Ethernet SNAP).
Xerox WorkCentre 7132 System Administration Guide